Fix duplicate atomic_t typedef conflicting with types.h

This commit is contained in:
2026-05-31 05:50:29 +03:00
parent 98326148ef
commit 3431bbfeb2
6455 changed files with 7049323 additions and 203 deletions
@@ -0,0 +1,80 @@
/* SPDX-License-Identifier: GPL-2.0-only */
/*
* Broadcom BCM63xx Processor Monitor Bus shared routines (SMP and reset)
*
* Copyright (C) 2015, Broadcom Corporation
* Author: Florian Fainelli <f.fainelli@gmail.com>
*/
#ifndef __BCM63XX_PMB_H
#define __BCM63XX_PMB_H
#include <linux/io.h>
#include <linux/types.h>
#include <linux/delay.h>
#include <linux/err.h>
/* PMB Master controller register */
#define PMB_CTRL 0x00
#define PMC_PMBM_START (1 << 31)
#define PMC_PMBM_TIMEOUT (1 << 30)
#define PMC_PMBM_SLAVE_ERR (1 << 29)
#define PMC_PMBM_BUSY (1 << 28)
#define PMC_PMBM_READ (0 << 20)
#define PMC_PMBM_WRITE (1 << 20)
#define PMB_WR_DATA 0x04
#define PMB_TIMEOUT 0x08
#define PMB_RD_DATA 0x0C
#define PMB_BUS_ID_SHIFT 8
/* Perform the low-level PMB master operation, shared between reads and
* writes.
*/
static inline int __bpcm_do_op(void __iomem *master, unsigned int addr,
u32 off, u32 op)
{
unsigned int timeout = 1000;
u32 cmd;
cmd = (PMC_PMBM_START | op | (addr & 0xff) << 12 | off);
writel(cmd, master + PMB_CTRL);
do {
cmd = readl(master + PMB_CTRL);
if (!(cmd & PMC_PMBM_START))
return 0;
if (cmd & PMC_PMBM_SLAVE_ERR)
return -EIO;
if (cmd & PMC_PMBM_TIMEOUT)
return -ETIMEDOUT;
udelay(1);
} while (timeout-- > 0);
return -ETIMEDOUT;
}
static inline int bpcm_rd(void __iomem *master, unsigned int addr,
u32 off, u32 *val)
{
int ret = 0;
ret = __bpcm_do_op(master, addr, off >> 2, PMC_PMBM_READ);
*val = readl(master + PMB_RD_DATA);
return ret;
}
static inline int bpcm_wr(void __iomem *master, unsigned int addr,
u32 off, u32 val)
{
int ret = 0;
writel(val, master + PMB_WR_DATA);
ret = __bpcm_do_op(master, addr, off >> 2, PMC_PMBM_WRITE);
return ret;
}
#endif /* __BCM63XX_PMB_H */
@@ -0,0 +1,48 @@
/* SPDX-License-Identifier: GPL-2.0-or-later */
/*
* Simple Reset Controller ops
*
* Based on Allwinner SoCs Reset Controller driver
*
* Copyright 2013 Maxime Ripard
*
* Maxime Ripard <maxime.ripard@free-electrons.com>
*/
#ifndef __RESET_SIMPLE_H__
#define __RESET_SIMPLE_H__
#include <linux/io.h>
#include <linux/reset-controller.h>
#include <linux/spinlock.h>
/**
* struct reset_simple_data - driver data for simple reset controllers
* @lock: spinlock to protect registers during read-modify-write cycles
* @membase: memory mapped I/O register range
* @rcdev: reset controller device base structure
* @active_low: if true, bits are cleared to assert the reset. Otherwise, bits
* are set to assert the reset. Note that this says nothing about
* the voltage level of the actual reset line.
* @status_active_low: if true, bits read back as cleared while the reset is
* asserted. Otherwise, bits read back as set while the
* reset is asserted.
* @reset_us: Minimum delay in microseconds needed that needs to be
* waited for between an assert and a deassert to reset the
* device. If multiple consumers with different delay
* requirements are connected to this controller, it must
* be the largest minimum delay. 0 means that such a delay is
* unknown and the reset operation is unsupported.
*/
struct reset_simple_data {
spinlock_t lock;
void __iomem *membase;
struct reset_controller_dev rcdev;
bool active_low;
bool status_active_low;
unsigned int reset_us;
};
extern const struct reset_control_ops reset_simple_ops;
#endif /* __RESET_SIMPLE_H__ */
@@ -0,0 +1,7 @@
/* SPDX-License-Identifier: GPL-2.0 */
#ifndef __LINUX_RESET_SOCFPGA_H__
#define __LINUX_RESET_SOCFPGA_H__
void __init socfpga_reset_init(void);
#endif /* __LINUX_RESET_SOCFPGA_H__ */
@@ -0,0 +1,7 @@
/* SPDX-License-Identifier: GPL-2.0 */
#ifndef __LINUX_RESET_SUNXI_H__
#define __LINUX_RESET_SUNXI_H__
void __init sun6i_reset_init(void);
#endif /* __LINUX_RESET_SUNXI_H__ */